Noise is signal spread over a large bandwidth, We tune our receivers to a
frequency to copy signals in a relatively narrow bandwidth. Nevertheless, there
is some of that noise in that same bandwidth. How does placing a resistor or
choke to ground reduce the noise while not reducing the signal at the same time?
Wes N7WS
On 12/19/2018 11:19 AM, Jamie WW3S wrote:
Since verticals are know to be "noisy" on receive, and a fix is a rf choke or
bleeder resistor to ground, anyone try that on short verticals used for receive only to
quiet some noise?
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|