Steve,
thanks for your patience digging out my signal of the noise! 160m QSO
with you is a highlite for me.
Vy 73 es cuagn,
Harry, DH1NBE
Am 09.12.2019 um 17:35 schrieb VE6WZ_Steve:
This was the first time I made a serious attempt at the ARRL 160m contest.
Usually I will just poke around and hand out mults. Since condx were looking
pretty good, I decided to stay in the chair a bit longer.
I must say I forgot how this contest is really more like SS with some DX thrown
in rather than a real DX contest. I knew the band was in great shape to EU
because of how loud the EU callers were, at least 4 of which were dupes. At
around 4 AM, John SM5EDX called in to tell me I had a great signal at his local
NOON! So I knew the band was in good shape over the pole at my morning. The
band was wall-to-wall during prime-time, but I could usually find a CQ hole
somewhere. If you left a run spot to go pee, it would be gone within about 1
or 2 minutes.
1319 QSOs (1381 total QSOs but 62 dupes!!! some guys just kept duping me, multiple
times…I just kept logging them)
83 sec (I worked all sections before I went to bed Friday night)
52 DXCC:
EU- 114 QSOs, 25 DXCC
AS- 97 QSOs, 5 DXCC: 86 JA, 7 UA9, 2 HL, 1 BY, 1 JT
OC- 8 QSOs, 2 DXCC: 7 KH6, 1 5W
SA- 3 QSOs, 3 DXCC: 1 CE, 1 YV, 1 PJ2
AF-1 QSO, 1 DXCC: 1 D4
I was operating my remote station using the Flex 6600, ACOM 2000a, 2 el TX, and
multiple RX.
My preferred radio is the K3s because it has superior weak signal RX, but it
has no waterfall via the remote.
My remote station is a challenge to operate a contest like this. Here is some
info on how things are set-up.
I am not "a boy and his radio", I am "a boy and his PC". I use the Flex 6600
PC software on one monitor, and the remote station PC is on the other monitor where I log with N1MM
and control the station. There is no physical radio or switching at the operating table. Just the
PC, a mouse and a keyboard.
I always use diversity RX with my 9 circle array in one ear, and the Beverages
in the other. Each has 8 compass directions and each are controlled with a
clickable rotor compass dial on the PC. SO...to change directions I need to
click the 9 circle, then click the Beverage selector, and then click the TX
array direction, then get the cursor back to N1MM to log. Often I would be RX
in multiple directions in each ear which was handy, but boy....Im pretty sure
I'm developing carpel tunnel syndrome from using that mouse! During the
morning run was really crazy...JA, OC, NA, N polar and EU all possible signal
arrivals!
If I was RX for JA, and some polar EU would call if I had one ear on EU I might hear them, but then
if they are weak, I need time to switch the other RX to have good copy. If the callers are only
dumping their call once…I might not get it. Same with NA calling from the back of the RX.
The Beverage broadside phased pairs are very sharp, and the difference can be copy-no copy just
between N to NE. I may consider adding my RBN skimmer 30m loop into the RX mix so I can have
“omni” rx, but it does not hear as well.
So if I missed any callers, or seemed really slow responding, it was probably
because I was busy switching my RX and struggling to get the mouse back into
N1MM to type in a call. This is one disadvantage of the remote compared to
having a physical direction switch so I could keep the focus on N1MM.
There were some very exceptional EU signals, some of which when they called I
was sure they were NA.
On Friday night at 0730z JE1BMJ and JE1CKA got my attention even though I was
RX for EU. This was just at JA sunset. I switched to JA and had a nice run on
41 JA till I went to bed at 0830z.
Congrats to Joel VE6WQ at VE6JY and Eric VE6BBP who were both rocking the band
during the contest.
Thanks to those how called me and could hear me.
Lets hope these great conditions persist throughout the season.
73, de steve ve6wz
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|