There is an old saying "The enemy of good is perfect." You will be driven
crazy by chasing down every slight variance from the ideal. That being said, it
is important to check out the obvious areas where flaws can create big
problems. Indeed, the feedline coax, typically RG6 CATV line, is a major
contributor to array performance problems. The cheap, big box cable is covered
with PVC and that stuff hardens and tightens up over the years. This allows
water to enter the shield and the water easily migrates for long distances,
creating a high resistance. Spend the money upfront and buy quality cable that
is flooded.
The idea of using cable that has a solid copper conductor has merit. But even
with that, a bare copper conductor will oxidize over time. I find myself
cleaning these conductors on an annual basis with the eraser end of a pencil
(recommended by Lee K7TJR).
I have also had F connector failures on my combiner box and on a common mode
choke. Sometimes the imported female connector center contact just fails for no
reason. The alternative Amphenol connectors are very expensive at about $8+
each but I am considering replacing the connectors with these higher grade
parts.
Also, the so-called "water-proof" compression connectors are often not. The
connection must be waterproofed effectively. Also, condensation from humidity
can be a big problem. Here is northeast Ohio, the environment is humid for the
majority of the year. I have poured water out of a 75 ohm preamp that was
sheltered in a good enclosure!
These complex phasing arrays are by no means plug and play. Each installation
will be unique depending on layout and surrounding objects. There are three
tools necessary to get them and keep them working: 1.) a good portable signal
source to feed the antenna preamps (I use an Elecraft XG-3 with a home brew
impedance transformer at the input); 2.) a portable transceiver to measure
signal out of the system at various points (My KX3 does a great job); and an
accurate antenna analyzer to measure impedances and to measure feedlines and
phasing lines for the proper electrical lengths. N6RK is right. There can be
considerable difference in RG6 impedance so you need to check it out.
73 Dennis W0JXMilan, OH
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|