Had the same problem with my Tailtwister in 25. I cut one of the diagonals at
the half way
point, pulled the out to where the beast would go in, and then pushed the
diagonals back in
place. Cut a 6" piece of diagonal from a junk section ( NEVER throw anything
away ) and
used large cable clamps to clamp it across the cut. Probably overkill, but
little trouble.
73
Ed
-------------------------------------
Name: Ed Sleight
E-mail: k4sb@avana.net
To: <towertalk@contesting.com>
Date: 1/12/97
Time: 1:03:46 PM
-------------------------------------
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|