Steve, Is there a rotator that will fit in Rohn 25 below the very
top without cutting out a cross brace? Currently, I am using an
Alliance 220D (which just fits on a tailor-made shelf). I would
like,however,to add more antennas to the mast and fear it wont
handle the load if it is at all windy. Currently, on the mast is
a DX Engieering 6-element 6-meter beam,a Cushcraft 17B2 and a KLM
440-16X. I need to add an antenna for 220, and will have to offset
it from the mast (which may cause me to put the 432 antenna on the
other side to achieve a rough balance).What about the Orion? John
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|