In looking at the thread, there is one thing I can't visualize. Do we FILL
UP the inside of the PL-259 with silicone grease, stick in the prepared
RG-8/U cable then wipe off the access that oozes out from the solder holes,
then solder?
Does the silicone grease have any effect on the soldering of the connector?
73's
Harvey, KM4JA
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|