Towertalk
[Top] [All Lists]

[TowerTalk] matching bolt grades to the application

To: <towertalk@contesting.com>
Subject: [TowerTalk] matching bolt grades to the application
From: w2up@itw.com (Barry Kutner)
Date: Fri, 10 Oct 1997 12:02:40 +0000
On  9 Oct 97, Don Moman <ve6jy@freenet.edmonton.ab.ca> wrote:

> My choice would be likely the grade 5 bolts, a good compromise between
> strength and brittleness. Gr 8 is very strong but in some cases will fail
> where a Gr 5 won't - I routinely lost 1/2 inch Gr 8's in a pinned mast
> (using 2 of them) turning a large log periodic and replaced with Gr 5 and
> they have lasted 5 years or so. They may be slightly deformed at the shear
> pressure points but they don't break clean like the Gr 8 ones did. 
> 
Could someone out in towertalk-land explain the coding on the head of 
a bolt to know what exactly it is? Tnx/Barry

--
Barry Kutner, W2UP              Internet: w2up@itw.com
Newtown, PA         FRC         alternate: barry@w2up.wells.com

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>