Towertalk
[Top] [All Lists]

[TowerTalk] Ham rotor

To: <towertalk@contesting.com>
Subject: [TowerTalk] Ham rotor
From: k1vr@juno.com (Fred Hopengarten)
Date: Wed, 08 Apr 1998 10:40:20 EDT
From:
Fred Hopengarten  K1VR               781/259-0088
Six Willarch Road
Lincoln, MA 01773-5105
permanent e-mail address:  fhopengarten@mba1972.hbs.edu

On Wed, 8 Apr 1998 05:59:15 +0100 "Shane Autrey NC4SA" <shane@icu2.net>
writes:

>Now that i have the wiring diagram for the rotor what do i need to do 
>so that the control box itself will recognise the direction the motor is
>pointing in. The Ham M control box reads the direction correctly but 
>when i wire up the Ham II control box the exact same way the control box

>gives absolutely no indication of direction. It stays all the way over
to 
>the right past the S on the scale.  

K1VR:  Sound as if you have the calibrate switch ON. Try to push a button
in or throw a switch. Or perhaps the calibrate switch is broken.

_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>