Tod Olson wrote:
The internal surface needs the same TLC before mating the surfaces.
>
> 73, de K0TO
This is easily done by using drill bits just a tiny bit less than the
id of the tubing. One you get to about 3/4" stuff, use a small auto
brake cyclinder hone. One pass in and out, and it's shining like new.
73
Ed
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|