Scott,
I cut aluminum flat stock with a fine
toothed carbide tip blade in my 10" table saw.
I wear a face shield to protect from the
flying aluminum chips. For round stock, I use
my metal cutting band saw with two "Vee" blocks
to hold the round aluminum in the saw's vice. I
use a drill press and a jig I build to drill
holes in the aluminum and keep them all in the
same plane. Good luck.
Roger K8RS
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|