Hi:
I'm very close to finalizing my remote control station. I have the rig
control lined up, amplifier, rotator control, software etc but need some
help with antenna switching.
>From all I have read, most folks use an lpt port for antenna switching.
In my particular case my only option is a serial port. I will have two
serial ports available at the remote end, one for rotor control and the
other is open and I would like to use it for antenna switching. Please
note I will NOT have a computer at the remote end just the rig, a modem
and a black box.
Does anyone know have a software/hardware set up to handle this?
--
73,
Richard Thorne
Amarillo, TX
Amateur Radio Station: N5ZC (previous calls, KA2DSY, N2BHP, WB5M)
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|