I had a tower up once with a beam on it. At the moment I don't. I really
enjoy reading about other folks tower and antennas. I am in a situation
where I use simple wire antennas now. I did learn a few things, or at least
I think I did. If I am all wrong in my assumption, I am sure you good folks
will tell me so.
The first thing I learned was that the bearing at the top of the tower was
nothing more then a line shaft bearing. The rotor contains the thrust
bearing.
Go to a place like a marine equipment supplier and you can see the
difference between a line shaft bearing and a thrust bearing.
Take a rotor apart and it is a motor assembly setting on a thrust bearing.
A line shaft bearing then can be anything. I looked at several and saw
nothing but trouble with one of those things hanging out in the weather. I
used a piece of split plastic PVC pipe around the mast so the the mast would
not rattle around inside the top tower section.
The antenna was a Cushcraft A4, the tower was 60 feet of Rohn 25G and I
forget the brand of roter now. Sure I was no "big gun" but did work 275
countries on CW before I took the tower down because of a move.
Oh yes, the mast was probably 8 feet of pipe. If 2 feet stuck above the top
section of the tower, then the rotor plate must have been 6 feet down inside
the tower.
I never had a bit of trouble with this install, but it was only in the air
for 5 years at the very most.
73 Jim K7SLI
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|