Hi
I've used one of those to open up boom materials that should fit but don't
due to slight machining errors such as a 1 3/4 OD that should fit a 1 3/4
ID but came a bit too large. It was easier than trying to file or grind.
I would think you'd have to be careful how much you expanded it so that it
wouldn't cause weakening. For most stuff I'd be tempted to use one size
smaller as a splice to join sections that had to be the same size
throughout.
Frank
W2FCA
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|