Just finished an 8 hour day on top of the tower removing my 10 year old T2X
and installing a new Orion 2800.
Before installing the rotor, I wanted to verify the Rohn 25 Rotor mount had
the right size holes and layout.....All was fine. After removing the T2X and
hosting up the #45 pound rotor I realized that the bolts were a different
size!!! Seems that Rohn had at least two styles of Rotor mounts. The one I
tested was an oblong hole and a 3/8 inch bolt just fit through OK....The one on
the tower was drilled in 4 spots with a 1/2 inch hole.....Ran back down the
tower grabbed the battery drill and drilled them out to 3/8 inch...No problem.
After a whole lot of mods with a hax saw I was able to get the Orion 2800
mounted. M2'd says the 2800 will only fit in the short top section of the Rohn
25, without mods. Mine was mounted 10 feet down. Cut at your own risk.....
After installing the steel clamps I noticed that I ran out of threads on
the bolts supplied with the rotor. Manual says Min size mast is 1.75
Inches....Mine was 2.0 and it wouldn't snug up.....I installed a few extra
washers and seems to be OK...Ill replace them with Grade 5 all thread next week.
So far it looks REAL good....I need to replace the cable with heavier gauge
wire, and that will be done tomorrow. Seemed like the T2X would work with
lighter gauge wire than the 2800....Even after the motor wires have been
doubled up.
Will take some time getting used to the digital readout...Sure miss the
Analog pointer on the Hy-Gain control....
See Ya! Rich N7TR
******************************************************
Richard Hallman N7TR N7TR@RNODX.ORG
11870 Heartpine St
Reno NV 89506 EX: KI3V, HL9RH
702 677-1106 A92FN, N3AMK
******************************************************
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|