No problem use distinctive ring and a device to switch to the correct
controller.
__
-----Original Message-----
From: Terry Sharar <terrys@romulus.ncsc.mil>
To: towertalk@contesting.com <towertalk@contesting.com>
To: <towertalk@contesting.com>
Date: Tuesday, December 08, 1998 11:58 AM
Subject: [TowerTalk] Tubes Separated!
Thanks to all who responded to my weekend posting asking for
suggestions on how to separate two concentric aluminum tubes. I received
many good, practical suggestions to include use of WD-40, hydrogen
peroxide, and propane torch heat.
I was not too worried about dirt between the tubes since I had
cleaned both thoroughly with paint thinner before inserting one inside the
other so I decided to try the chemical route first. Starting on Sunday
morning I began squirting "Kroil" on both end of the tubes. This is a
penetrating lubricant similar to Liquid Wrench or WD-40. I did this
aperiodically about half a dozen times during the day. I allowed it to
soak and wick all day Monday while I was at work.
The tubes were concentric except for about six inches on the ends.
Fortunately, there were holes at each protruding end through which I was
able to insert short steel rods. On Monday evening I began to gently twist
and pull. The tubes began to twist within two minutes and within another
three minutes I had them completely separated!
I hope this experience will be of benefit to others who may be in
a similar predicament.
73 de Terry Sharar WB3DSB
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|