Esteemed TowerTalkians and CTers,
With assistance from F12 and K7LXC, I'm putting together a 3-stack on a
120' tower (base at 210' above MSL, looking over my cliff at saltwater to
the horizon). The 3 antennas will be rotatable individually, but I'm also
looking for experienced advice on the feasibility of "ganging" the computer
control of the stack when desirable. I want to maintain my objective of
having the entire station as close to "look down/shoot down" as feasible.
Let's assume I am using the latest version of CT which controls both
rotators described below. I'm asking this now because it influences my
hardware choice for the middle rotator.
The details:
o C51XR/H 40-10 on a 51' boom, 15+ sq ft, top-mounted at 120' (330'
above MSL), rotated by an Orion 2800
o C31XR/H 20-10, stackable with the '51, around 10 sq ft,
side-mounted at 75', rotated by either an OR2800 or a T2X (discussion
below)
o C51XR/H side-mounted at 30' (240' above MSL), rotated by an Orion
2800
o Phasing will be by 2 WX0B Stackmatches (one ea for 40M and for
20-10), with dual feed option to "break the lower C51XR out of the stack"
for SO2R, M/S
My desires:
o When pointing the antennas separately, use "Rotor 1" and "Rotor 2"
to control at least 2 of 'em out of CT--ideally all 3 (???)
o When ganging at least 2 of the antennas, be able to direct both/all
3 antennas automatically with a single command (probably need to build a
special
switch to tell the rotator controls which mode we're in)
Are these desires both feasible?
If yes, can I control a T2X/DCU along with one or both OR2800s without
additional programming, or should I consider the additional $ US to have a
matched set of 3 OR2800s?
Please reply directly to me and I'll summarize.
73,
Jim, VE1JF/XJ1JF
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|