[Top] [All Lists]

[TowerTalk] C3S initial install questions

To: <>
Subject: [TowerTalk] C3S initial install questions
From: (Mark L.)
Date: Mon, 02 Aug 1999 13:20:19 GMT
Hello Barry;

Yes, choke baluns really work.
I just finished assembling my C-3E, including the choke balun. It takes many 
feet of coax to make the pigtail for this antenna when you account for the 
balun (I chose 8 turns at 7.5" OD), and a multiple turn compliance coil for 
rotation (3 turns at 12" OD). Those two coils alone add up to about 25 feet. 
Add to that the desired runs along the boom and mast.....and I used about 
30-35 feet of coax.

I chose RG-213 with solid dielectric to prevent the center conductor from 
migrating over time, which can be a problem in the heat of summer with the 
foam dielectric types formed into such a curve.

I wound my balun on a gallon paint can with 8 turns. Don't wind too tight or 
you won't be able to slip it off the crimped can edges! Surprise! ha ha ha

I plan to pull the beam partway up in the air first, on a non-metallic tram 
line, and connect my analyzer to the pigtail to check the SWR curves before 
'popping' the rivets in the 15 and 10m adjustable elements. I'm holding the 
adjustable segments in place with a single, un-popped rivet, held in turn, 
by a short piece of tape impaled over the rivet's mandrell.

During assembly of the antenna elements, I discovered one possible source of 
trouble: If the rivets holes do not line up *EXACTLY*, stop and flip that or 
the adjoining piece of tubing end-for-end and look again. As confirmed by 
Tom at Force 12, some of the pieces get flipped during packing. There is 
only one orientation where all rivet holes line up exactly. I checked the 
orientation of all pieces in each element before popping the first rivet.
Also, faint swage marks appear on some segments. These always pointed away 
from the boom, and served as an additional clue to flipped segments.

Good luck Barry,


Get Free Email and Do More On The Web. Visit

FAQ on WWW:     
Administrative requests:

<Prev in Thread] Current Thread [Next in Thread>