Towertalk
[Top] [All Lists]

[TowerTalk] Re: [Yaesu] G-800S problem (additional #1)

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: [Yaesu] G-800S problem (additional #1)
From: w8tts@gwis.com (Ted Sarah)
Date: Sun, 24 Oct 1999 14:18:50 +0000
Well so far I've had time to try the following suggestions and ideas:

    1.    Turn off the 2 meter rig.  Did this and the problem went away, but
of
            course so did my packet connection <BG>
    2.    Ground to case of the rotor control.  Tried many different points
and
           no change.
    3.    Checked the SWR on the 2 meter rig.  SWR is below 1.1 to 1.
    4.    Dropped an e-mail to Yaesu tech support.  No answer yet!

I'll keep trying things and let everyone know.

73 - Ted - W8TTS

Ted Sarah wrote:

> I just installed a G-800S rotator and have an interesting problem.  When
> it's on every once in awhile the pointer moves a little, about 5
> degrees, and then goes back to the correct spot.   This would happen
> every minute or so.  I couldn't figure it out, checked the wiring, etc.
> and every thing was fine.  Then I happened to note that it happened
> every time my 2M packet radio, Yaesu FT-8000, transmitted.  Go figure a
> rotator with an RF problem.  Any ideas on how to correct this other than
> the usual torid cores on the cable?
>
> 73 - Ted - W8TTS
>
> --
> FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
> Submissions:              yaesu@contesting.com
> Administrative requests:  yaesu-REQUEST@contesting.com
> Problems:                 owner-yaesu@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Re: [Yaesu] G-800S problem (additional #1), Ted Sarah <=