Hi Mike,
If you think Rohn is bad, look at the others. We found when purchasing new
Rohn tower, delivered by their truck, we had no problem. The ends on any
tower can be slightly bent by improper handling. When we install used
sections, we check the alignment of the legs and ends. If the ends are not
bent over 3/8" out of alignment, we bend them back into alignment.
Here is a question? What happens to any steel when it is plated or
galvanized?
Happy
Holidays,
Bill Wall
KC4UZ
Quads are
better
k4ydk wrote:
> >From what I have seen the last few days on this SIG. I wouldn't buy a
> Rohn tower. If that many people have experienced that much 'shoddy'
> workmanship, I'll spend my money somewhere else. Thanks for the info,
> 73-Mike
>
> --
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|