I just noticed that Home Depot sells a 200 foot reel of bare
#4 wire for $36.
If I cut this into four 50 foot lengths and CADwelded it to my
four ground rods would it be an acceptable substitute for a
single run of 0/0?
Will I need to twist the four wires together?
Will the mould for the CADweld process keep the tension off the
individual wires so they don't melt and pull apart?
- Thanks! & 73, DavidC K1YP
************************************************************************
__________________________________________
NetZero - Defenders of the Free World
Get your FREE Internet Access and Email at
http://www.netzero.net/download/index.html
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|