Wayland,
If it is a commercial tower, then you need a professional engineer to design
the tower. An engineer has gone to college to learn the things you are asking
about. You are asking very fundamental, but complicated questions that could
take a book or the better part of the day to answer.
I hope that you will not endeavor to "OVER ENGINEER" your tower without the
proper professional help.
Tower2sell@aol.com
In a message dated Wed, 28 Feb 2001 1:34:34 PM Eastern Standard Time, "Wynand
van Wyk" <zs6arf@telkomsa.net> writes:
<< Hi there,
I asked before but did not get a response ...
I am busy erecting a 15 meter high ( 49 feet) commercial triangular steel
tower sitting on a T-piece base that bolts into the concrete. The three
legs of the tower slides into three tubes welded onto the T-piece.
Can someone please explain to me how (1) the forces of gravity and (2) wind
pushing against the tower will put stress on the legs and where the danger
points could be. Will there be a difference between a guyed and unguyed
tower, I would like to not use guys.
In the process I have over engineered which is adding extra weight. I have
heard that thicker steel is not necessarily going to calculate as more
strength ... howcome ?
73
Wynand van Wyk
ZS6ARF@telkomsa.net
--
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
>>
--
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|