TT'ers
In the past few weeks I have asked 2 questions "Removing Oil from a motor"
and "Cutting large holes in aluminum". I want to thank all that sent
suggestions. Too numerous on "Oil removal" but on "Cutting large holes"
thanks to KI7WX, K3BHJ, K7GCO, N9IWW, Dan, KC4UZ and especially KB7WW who
sent me detailed messages and step by step instructions on doing it in a
lathe. Thanks to everyone for their time.
Mike W9RE
List Sponsor: Are you thinking about installing a tower this summer? Call us
for information on our fabulous Trylon Titan self-supporting towers - up to
96-feet for less than $2000! at 888-833-3104 <A
HREF="http://www.ChampionRadio.com";>
www.ChampionRadio.com</A>
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|