Hi all,
Rework of all antennas has led to rework of feedlines and control cables . . .
I plan to reroute and secure the cables up the entire length of the tower. I
don't like the previous methods I've used:
1. Cable ties around tower legs add another place for your climbing lanyard to
bind on.
2. A lot of cable ties suffer from environmental breakdown.
3. Electrical tape is pretty good, EXCEPT when you need to change a single
cable, you don't want to remove them all! How do you attach cables to tower
legs so they are individually serviceable?
Currently, this Rohn 25 tower has six RG-213 runs, one 1/2-inch hardline run
and three control cables terminating at various heights.
73,
Jim K1IR
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|