Best way to do this is with a RoTek bearing. BUT....... the cost of the
bearing and the cost of the concrete would far exceed the cost of guy
bearings and guy wires .....
de Rich K0XG
www.qth.com/k0xg for rotating tower parts.
----- Original Message -----
From: "Jack" <poster@gate.net>
To: <towertalk@contesting.com>
Sent: Tuesday, August 28, 2001 8:55 PM
Subject: [TowerTalk] What is a good way to rotate a tower?
>
> Has anyone ever used a large gun turit to sit a tower onto and then turn
> it through tower rings.
> If the tower was self supporting no rings would be needed.
>
>
> Jack
> wb4roy
>
>
> List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
> Trylon Titan towers, coax, hardline and more. Also check out our self
> supporting towers up to 96 feet for under $1500!!
http://www.anwireless.com
>
> -----
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
>
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|