Hi 4-square fans...
I currently have an Inv L 4-square on 80 that is around my 130' tower. The
4-square elements are elevated with elevated radials and the element ends
point AWAY from the tower and AWAY from each other.
Due to space limitations, I am contemplating hanging a pair of phased 160
Inv L's from the 115' level on my tower and angling them out away from the
tower and away from the 4-square. The ends of the 160 Inv L's will be
elevated with elevated radials and will be phased with 3/4 wavelength
coaxial lines. The ends of the 160 elements will be 1/2 wave apart - about
270'. The ends will be about 100' from the 80 4square InvL elements but the
radials will come closer than that to the 80 4-square radials.
I think that some pattern degradation might result but I don't think it
should be very serious. Any thoughts on this? There is no other good
alternative for 160 at this qth.
All help and comments appreciated.
Many thanks and 73
Bob KQ2M
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|