Towertalk
[Top] [All Lists]

[TowerTalk] 80m Vertical ssb/cw switching

To: <towertalk@contesting.com>
Subject: [TowerTalk] 80m Vertical ssb/cw switching
From: n4kg@juno.com (n4kg@juno.com)
Date: Wed, 14 Nov 2001 15:23:47 -0600

On Wed, 14 Nov 2001  Stephen Reichlyn 
<Stephen.Reichlyn@ryansci.com> writes:

> Tom:
> 
> If you had your choice, would you make an 80M (cut to 3510) vertical 
> the  correct length and use a transmatch to operate on 75M (3890) 
> or cut the vertical  for 3890 and use the transmatch to tune on 3510?
> 
> 73, Steve AA4V
> 

Hi Steve,

It probably doesn't make much difference.  If you tune
it for SSB, you could add a small coil to tune for CW
using a aligator clip or leave the coil in place and short
it out with a wire / clip or relay.

If I didn't want to switch at the antenna, I would tune
it for CW and use a tuner on SSB.

My 80M wire vertical has a double dip at 3525 and 3800.
It consists of one half a bow tie, 62 ft high with 2 ft separation
at the top.  I used a wooden spreaded and supported by an 
upside down Y and a rope over a tree limb. It is fed with 1/4 WL 
of 50 ohm RG58 followed by 400? ft of75 ohm CATV line to the shack.

I'm copying my answer to TowerTalk 
since this question has broad interest.

Tom  N4KG


________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.

List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>