At 02:35 PM 1/1/02 -0600, K9ZM wrote:
...
>Now that's a novel idea. Do you just mount your roll of wire near the tower
>and sew your way around the lawn? Your south of the freeze zone I think,
>anyone have success doing that into a frozen lawn? I know that idea about
>scalping the lawn and waiting for grass to grow over it, but this would
>allow me to go places that I normally could not. i.e. down the alley etc.
>Anything I can do to hide it from rabbits is a plus as they like to chop my
>radials into little pieces, if laying on top of the ground. They have not
>bothered coax yet, but give them time.
Things are frozen pretty solid here, unfortunately -- tends to deter tower
work. In my case, the tower is in a back field which is somewhat overgrown
with brush, multiflora rose, etc. Using K1VR's big carpet needle let me
push the radials through under the rose thorns, etc. I don't want to
oversell this, though - you can't go very deep -- really just into the
thatch layer, and even then you have to resurface every so often.
I got 12 x 125 foot radials in this way before it got too cold. I attached
the tower end of each one to my radial plate, and then laid it out on the
ground more or less in the opposite direction from where I was going, and
stitched away. It was pretty easy to tell when you got to the end of the
radial, even working alone.
73, Pete N4ZR
The revised World Contest
Station Database
is online at www.pvrc.org
This list is sponsored by the new eHam.net Store. When you buy products
like ICE filters, Array Solutions StackMatch, or M-Squared Antennas from
the eHam Store for the same price you pay direct, a portion of the sale
price goes to support this list. Check it out at http://www.eham.net.
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|