David, I agree with WC1M suggestions. Additionally, I would suggest the =
installation of a "T" in the middle of the run that would drain into an =
underground "French drain"; a bucket-sized hole filled with gravel. An =
amazing amount of condensate will accumulate over a period of time, and =
literally bathe your coax and control cables in water. A gentle slope =
on either side of the "T" will allow the condensate to run into the hole =
to absorbed into the ground. I would bring the pipe up alongside of =
rather than thru the base. While the latter looks nice, it might be a =
PITA later on should you ever have to modify your conduit run. When I =
ran mine, I purchased all the materials from Home Depot with also =
carried the sweeps you'll need for the 90's. I have four 90's in my =
run, and had no problems chasing a "ghost" thru the pipe using the =
exhaust from a shop vac and a string tied to a plastic bag. This was =
followed up with the actual pull rope. My 3" conduit contains one 7/8" =
Heliax, one RG8, rotor control, coax switch control, one weather station =
control, and a length of pull rope. With the exception of the weather =
station, all were pulled at once with the help of Ideal wire lube and my =
really big kid! I fed, he pulled. Remember that unless you can chase a =
future ghost thru the conduit, the pull rope you have in there will wrap =
around the existing cables as they were fed thru the run. Future runs =
can be difficult to pull, so try to do as many as you can at once. A =
larger than required pipe will also facilitate a fresh pull line easier =
than one that's just big enough. Good luck with your installation.
7 3,
Tom K3GM
Sturbridge, MA
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
---
|