Towertalk
[Top] [All Lists]

[Towertalk] Proper way to ground open-wire feeders

To: <towertalk@contesting.com>
Subject: [Towertalk] Proper way to ground open-wire feeders
From: W8JI@contesting.com (Tom Rauch)
Date: Sun, 4 Aug 2002 16:30:45 -0400
> Hello All,
> I have been enjoying this list, especially recently with all the text
> about grounding. My question is about how anyone is grounding 450-ohm
> line as it enters the house. My antenna is only up about 30 feet, so
> maybe not a big lightning risk, but I am concerned just the same. I
> did have the line coming in a basement window, then a small knife
> switch with one side connected to the cold water pipe - I was uneasy
> about bringing lightning inside for that.

I'd disconnect it outside, and let it lay away from the house if 
possible. I would not ground it to anything, as long as I could get 
the wires loose and away from the building and away from valuable 
lifeforms.

Short of that, I'd use a spark gap. The problem is with open wire 
line the voltages can be very high even with modest power, so you 
sometimes need a very large gap!

Open wire or ladder line, or a single wire feed, are probably the 
worse things in the world to handle short of tossing em out in the 
yard before storms arrive. DO NOT depend on a ground, especially 
through a balun or small switch! A knife switch would never work 
reliably on a nearby or direct hit.



 


   73, Tom W8JI
W8JI@contesting.com 


<Prev in Thread] Current Thread [Next in Thread>