Hi Paul,
My 4 sqr uses 1/4 wave ground mounted elements and when i erected a 3 wire
electric fence also 4 ft high sometimes closer than a 1/4 wave from the
elements i noticed no change in freq. or for that matter power into the
dummy load.
73
Nick ZL1IU
----- Original Message -----
Subject: [Towertalk] 80M 4 Sqr resonant point jumps way high...any ideas
why?
> I use a comtek systems hybred coupler with 4 1/4 wave top loaded verticals
in
> an 80 meter array. Testing the system out before the winter season, I've
> found that the array's resonant point has jump 400KHz to apprx 3.990MHz
from
> where each individual antennas are tuned at +- 15KHz at 3.600MHz. The
array
> has always jumped 200KHz, over three rebuilds, using various lengths of
> verticals and top loading wires. So this major jump on the surface is
> unexplained. In looking over the array, I have decided to replace the
> feedline connections as some were getting weathered. I also recently put
up
> a 4 foot tall 3,800 foot goat wire fence on the west side of the array
just
> past the 1/4 wave ground radial field. Could this be the culprit in all
of
> this. I am wondering if anyone with a 1/4 wave vertical array has ever
> noticed such a change and if so, what caused it-. In my research, I have
> found most arrays constructed like mine jump around 100KHz from where the
> individual antennas are tuned due to interaction inside the array,
phasing,
> and factors in the environment. The explanation for mine originally going
up
> 200KHz was that it was in the clear without anything around it- And it
worked
> great! Now a simple fence is causing it to jump 400KHz???? Can't be that
> simple????
>
> It's either the 1. Fence 2. Feedlines are screwed up 3. Comtek Box
problem
> 4. One of the verticals is screwed up but this has been ruled out- 5.
Your
> suggestion here??
>
> The F/B is down a bit, no matter where I am on the band-
>
> 73 Paul N0AH/7
|