rake next size up diameter wise screw- or tap - thread it into the
"Chad" - be careful not to "Gore" it - then pull out....
K4OJ
RICHARD BOYD wrote:
>
> Any ideas on a good or the best way to get the "chad" out of the
> Greenlee punch after punching a hole?
>
> I'm making a single point ground incoming coax bulkhead out of a sheet
> of copper.
>
> By the way, I realize the diameter of my radiator on my 80M vertical
> has a bearing on bandwidth. It's 14 gauge copper wire, insulated.
>
>
> Rich Boyd
>
>
> KE3Q/W3AO
>
>
>
>
> _________________________________________________________________
> STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
> http://join.msn.com/?page=features/junkmail
>
> _______________________________________________
> AN Wireless Self Supporting Towers at discounted prices, See
> http://www.mscomputer.com
> Wireless Weather Stations now $349.95. Call Toll Free, 888-333-9041
> for additional information.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
|