I am going to put my M2 rotator in the top section of
my tower. The top section will be a regular Rohn 25
section with the flat top mini section that is about 2
feet tall and will have the thrust bearing in it. Its
obvious that the rotator should be as low in the tower
as possible. There are about 8 rungs that I can place
the rotator and rotator plate on in that section. It
is also obvious that I will have to saw off one rung
at the location I want the rotator. Does anyone have
a preference for the the rotator in that section? As
low as possible?? That means just above the junction
of the top section and the one below it. I will also
put an additional rotator plate above the rotator with
a sleeve so I can clamp the mast if the rotator has to
be removed. Appreciate any comments on this proposal.
Steve K7AWB Spokane Valley
__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
|