Towertalk
[Top] [All Lists]

Re: [TowerTalk] T2X Control Box Creating RFI

To: "Mike Warnock" <k7xn@cox.net>, "Dan Levin" <djl@andlev.com>,<towertalk@contesting.com>
Subject: Re: [TowerTalk] T2X Control Box Creating RFI
From: "on4kj" <on4kj@skynet.be>
Date: Fri, 19 Sep 2003 16:03:48 +0200
List-post: <mailto:towertalk@contesting.com>
Mike, dont you have a High Tension cabin in that direction?.
I observed this phenomena, but there is such a HT cabin at about fourty
yards from the foot of my sixty-five foot tower. But noise  can be worst
when the cabin is situated at a longer distance.
What do we do when BPL will be there.?

Have fun

Jos on4kj
----- Original Message -----
From: "Mike Warnock" <k7xn@cox.net>
To: "Dan Levin" <djl@andlev.com>; <towertalk@contesting.com>
Sent: Friday, September 19, 2003 3:15 AM
Subject: Re: [TowerTalk] T2X Control Box Creating RFI


> I recall a similar problem at my previous qth.  When my antenna was
pointed
> in a particular direction, NE as I recall, the swr and noise rose
> significantly and would vanished when the antenna was turned 30 to 45
> degrees away.  Never did figure it out. As I recall some bands were worse
> than others.  I do not have the same problem at the new qth.  Probably
> should have researched deeper.
> ----- Original Message -----
> From: "Dan Levin" <djl@andlev.com>
> To: <towertalk@contesting.com>
> Sent: Thursday, September 18, 2003 11:30 AM
> Subject: [TowerTalk] T2X Control Box Creating RFI
>
>
> > I vaguely recall a thread on this in the past, so
> > my apologies if this is a repeat.  I can't find
> > the old thread in the archives...
> >
> > I have recently isolated my rotor controller box
> > as the source of a long standing "feedback" problem
> > in my shack.  When the rotor controller is connected
> > to the rotor, and the antennas are pointed in certain
> > directions, I get a "roar" on my transmitted audio
> > if I transmit with more than a certain amount of
> > power.
> >
> > The amount of power depends on the directions that the
> > antennas are pointed in (big surprise).  If the rotor
> > controller is not connected to the rotor, the noise
> > goes away.  The controller is a standard Hy-Gain
> > Tailtwister controller.
> >
> > Does anyone have experience with such a problem,
> > and hopefully a recommended solution.  Please be
> > specific, my technical expertise in this area is
> > less than might be desired :-)
> >
> > Thanks much!
> >
> >                   ***dan, K6IF
> >
> > See you all in the California QSO Party,
> > October 4-5!
> >
> >
> >                   ***dan
> > _______________________________________________
> >
> > See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
> Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with
any
> questions and ask for Sherman, W2FLA.
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>