[TowerTalk] Yaesu G1000SDX

[Erik Jakobsen <eja@urbakken.dk>]

Hi.

I have a problem with my G1000SDX's controlbox. As you know, it has a 
speed controle, a pot. for presets, and a preset switch.

I have travelled through the circuit diagram, and have measured on the 
PCB. I cannot measure any voltage on pin 14 of the 4001 chip. If looking 
at the prsete's B9, and following that line, it come to a point, where a 
line goes down, and here there's print 14. I assume that's the pin 14 on 
the 4001. for the point where the line goes down, also a line goes up, 
and its marked "c".

I have the idea, that here I should could measure a constant voltage, 
but I cannot find where the "c" line is connected in it other end.

Can any of you help me to find it out.

Thanks very much in advance.
--
Med venlig hilsen - Best regards
Erik Jakobsen - eja@urbakken.dk
Hamcall OZ4KK
SuSE Linux 9.0.

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk