I have an ICE model 302 (U) lightning arrestor, used for 2m,
and started having intermittent SWR swings. I took the arrestor
out, as something to try first. (I'm still not sure if that was the
issue or not.)
Anyway, I took the covers off to look inside, and now am not
sure which way to put it back together. This is just a bit
embarrassing... but I can't tell which is the "Rig" SO-239
and which one is for the "Antenna".
There is a picture of one about halfway down the page at
http://www.arraysolutions.com/Products/thorshammer.htm
-- the first pic with the covers off. Is the "Rig" side the one
with the bleeder resistor, or the one with the gas tube?
I have no other ICE coax protectors to compare it to.
(Without trying to start a debate on lightning arrestor brands/
designs, I have some of each, ICE, AD, and PolyP -- just
happen to have only 1 ICE coax model, though I have 2 of
their rotor controller units.)
Thanks & 73,
Dave NØRQ
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|