[TowerTalk] MFJ analyzer woes

["Rob Atkinson, K5UJ" <k5uj@hotmail.com>]

Regarding the problem with the MFJ swr analyzer, I noticed something 
interesting with mine a few weeks ago (I own the 259 or is it 269?  the one 
with UHF coverage) when I was using it to tune my transmatch on my open wire 
feed to my horiz. loop.  At night I was unable to tune the transmatch below 
a 1.4:1 swr and the analyzer showed around 10 to 20 ohms reactance. I 
normally can tune the matching network so the rig sees a nice 50 ohm load 
with no reactance, i.e. 1:1.  I went ahead and operated figuring there was 
just something goofy outside like a lot of water on the line and in the 
daytime the problem was gone.  Over time, I noticed this problem correlated 
with a relatively new (now gone) presence of 20 db over 9 line noise all 
over the HF spectrum which I had been temporarily getting rid of with a 
noise blanker pending time to find it.
If you have a big antenna and some powerful nearby source of HF RF junk, 
this might be throwing your analyzer off and making it give you a false 
reading, i.e. the problem doesn't have to be a mw bc station.

rob/k5uj

_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee® 
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk