To: | "Arthur Moe" <kb7ww@easystreet.com>, "Peter" <pc2a@pi4cc.nl> |
---|---|
Subject: | Re: [TowerTalk] Ham IV bearing balls |
From: | "Floyd Sense" <fsense@copper.net> |
Date: | Fri, 19 Nov 2004 17:07:51 -0500 |
List-post: | <mailto:towertalk@contesting.com> |
You might also want to take a close look at the bearing races. I acquired
an old and apparently abused Ham IV last year and the bearings didn't look
good. When I cleaned up the races and looked at them closely, they were
badly dented from the bearings. Apparently the rotor had been overloaded,
damaging the races. Unfortunately, the races are simply cast into the
ALUMINUM housing and are not very forgiving. I was able to buy replacement
housing castings from the usual rotor parts sources for a reasonable price. K8AC ----- Original Message ----- From: "Arthur Moe" <kb7ww@easystreet.com> To: "Peter" <pc2a@pi4cc.nl> Cc: <towertalk@contesting.com> Sent: Friday, November 19, 2004 4:56 PM Subject: Re: [TowerTalk] Ham IV bearing balls Peter, _______________________________________________ See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA. _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Ham IV bearing balls, Arthur Moe |
---|---|
Next by Date: | Re: [TowerTalk] Looking for some tower advice, Alan C. Zack |
Previous by Thread: | Re: [TowerTalk] Ham IV bearing balls, Arthur Moe |
Next by Thread: | Re: [TowerTalk] Ham IV bearing balls, John Tait |
Indexes: | [Date] [Thread] [Top] [All Lists] |