To: | Mark Potter <jbpmlp@comcast.net> |
---|---|
Subject: | Re: [TowerTalk] Slipp-Not Clamp for rotors |
From: | NOLL AMIDZICH <namidzich@wi.rr.com> |
Date: | Tue, 01 Feb 2005 19:52:03 -0600 |
List-post: | <mailto:towertalk@contesting.com> |
Mark, I have been using the slipp - not clamp since April 2004. The clamp is used on a tailtwister. The rotor turns a kt34xa and a 5 el 6 mtr beam. Before installing the clamp, I would have to re- orient the antennas on an average of once a year minimum due to high winds. (I tried to exercise "wind management" by pointing the booms of the antennas into the wind but wasn't always successful for various reasons). I always felt it was better to let the mast slip a bit then to pin the mast and risk rotor damage. Since installation, the mast has NOT slipped at all. Even with winds in excess of 50 MPH. In fact , the very first weekend after installation , our area (Milwaukee, Wi) had winds exceeding 50 MPH. The clamp was put to the test very quickly and performed very satisfactorily. The usual, no affiliations with the manufacturer, just a very satisfied customer. 73 Noll W9RN Mark Potter wrote: Would like to get opinions on how these work. Am using a 2" mast with a T2X rotor., TB-3 Thrust bearing. Now about 12 sq. ft. load. Going up to about 20 sq. ft. Had to pin the rotor to the mast to keep it from turning. _______________________________________________ See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA. _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] stainless bolts freezing up, WA4MWM |
---|---|
Next by Date: | [TowerTalk] Yagi Boom to Mast Clamps, N7KA |
Previous by Thread: | [TowerTalk] Slipp-Not Clamp for rotors, Mark Potter |
Next by Thread: | Re: [TowerTalk] Slipp-Not Clamp for rotors, Jim Jones K0HY |
Indexes: | [Date] [Thread] [Top] [All Lists] |