Eddie:
Use a pair of through-bolts (1/4" SS) and hardware instead of rivets.
Much sturdier.
73 de
Gene Smar AD3F
----- Original Message -----
From: <wb4mle@ctvea.net>
To: "TowerTalk" <towertalk@contesting.com>
Sent: Friday, February 04, 2005 2:48 PM
Subject: [TowerTalk] Boom splice securing
> I have a HyGain TH3-MKIII that has about 1 foot of the boom gone from a
> fall. I have a piece of another boom- same size with a swage that will go
> into the boom 5 inches (2 1/2 inch split in boom). I plan to use a hose
> clamp and think I should rivet the splice to the boom at the split outside
> ends to control torqueing. If I use rivets, I feel the split should face
> UP, as facing downward will tend to open or bulge the split with downward
> force. The split will be sealed with butyl rubber and chrome tape under
the
> hose clamp.
> Am I missing/overlooking something with this plan?
>
> Thanks!
> Eddie, WB4MLE
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|