Hmmm .. I always used to use a crowbar .. did not take long to do, and
because of the way it could be hooked, was easier to not hit the ground as
it went round and round. Be sure the angle is towards the tower, unlike our
old Boy Scout tent pegs... but, suspect you know that! HIHI 73, Mark ..
AA6DX
----- Original Message -----
From: "J Boothe" <technicaltheory@yahoo.com>
To: <towertalk@contesting.com>
Sent: Friday, April 29, 2005 3:50 PM
Subject: [TowerTalk] Installation procedures for the Rohn GAS604 screw
anchor
>I am in search of the best way to properly install the Rohn GAS604 screw
>anchor. I am setting up a few 30' rohn 25G towers. I called Rohn directly
>to get there input from the manufacturers point of view. The best
>suggestion was to manually spin it into the ground with a steel pole
>through the eylet. This seems to me to be extremely difficult and not the
>installation of choice.
>
> Has anyone used an auger drill and inserted the GAS604 as the auger bit
> (so to speak) if so what type of auger unit was used? would that work?
>
> I am open to any proven logical field applications
>
> thank you in advance for your assistance and suggestions
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|