Hi Terry...
I just finished installing a 350ft run for a M2'd 2800DC. I ran two
runs of #12 Burial Romex (250ft roll for $45 at Home Depot) from the
house to the tower (About 200 ft each, total of 6 Conductors - but only
used 4), then used 6 conductor #18 (From Cable X-perts) for the tower
and under the house to the shack. Doubled up two of the conductors for
the power, and the others for the reed switch sensing on the 6 conductor
cable.
So far it has worked flawlessly, but I've only had it working for the
past day or so.
73 Rich N7TR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of W6RU@aol.com
Sent: Sunday, June 26, 2005 6:06 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] M2 Readout Loosing Pulses ?
It looks like I am having the problem I was warned might happen ....
with a
long run of rotor cable (abt 275 feet of RG-58U for reed switch) I am
loosing
pulse counts and the direction indicator is loosing calibration. Anybody
else
had this problem and found a fix for it ?
TNX,
Terry W6RU
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
any questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|