Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 25 base3

To: Pete Smith <n4zr@contesting.com>, K7LXC@aol.com,towertalk@contesting.com, giw@bellsouth.net
Subject: Re: [TowerTalk] Rohn 25 base3
From: Bill Aycock <baycock@direcway.com>
Date: Thu, 04 Aug 2005 16:37:23 -0500
List-post: <mailto:towertalk@contesting.com>
Pete- Yes, there is (or was) such a base.It is actually a tilt-over base 
plate, No. C-750112.  BPH-25G.

The plate has two hinge pins, and two lock bolts. This is mounted on the 
lower plate that is the one with the 4 bolts to hold it down.
  I have one. I could take a pic, and send it off-list, if needed.
Bill-W4BG

At 02:39 PM 8/4/2005 -0400, Pete Smith wrote:

>Does Rohn really make a base plate like this?  The only one I'm aware of
>for 25 is the pier pin base, which has one hole in the middle (more or
>less).  For a guyed tower, the base requirements are really minimal -
>sufficient resistance against downforce and a little for lateral movement
>of the base -- in fact, some analyses suggest that the pier pin, where the
>base is free to tilt or twist a little, may be the best from the standpoint
>of distributing stresses (or anyhow, avoiding a "hot spot" at the bottom.
>
>So maybe all you need is a pier pin and 1 8-inch hole.
>
>73, Pete
>
>At 12:38 PM 8/4/2005, K7LXC@aol.com wrote:
> >In a message dated 8/4/2005 9:07:24 AM Pacific Daylight Time,
> >towertalk-request@contesting.com writes:
> >
> > >  A friend wants to replace and old free standing hbx tower with a new
> > Guyed
> >60 foot Rohn 25. He wants to use the old concrete in the ground  by using a
> >new Rohn base plate and drilling 4 holes into the old concrete and adding
> >large
> >long bolts and using epoxy to hold them in. Does anyone have experience with
> >this approach and any positive or negative comments. thanks van
> >
> >     Yep, that's the way you do it. Rent an impact drill and bit and you're
> >good to go. Drilling doesn't take long at all. The rental place probably
> >has the
> >industrial concrete epoxy you need too. BTW the epoxy is stronger than the
> >concrete. People use this technique every day.
> >
> >Cheers,
> >Steve    K7LXC
> >TOWER TECH -
> >Professional tower services for commercial and amateur
> >Cell: 206-890-4188
> >_______________________________________________
> >
> >See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
> >Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with
> >any questions and ask for Sherman, W2FLA.
> >
> >_______________________________________________
> >TowerTalk mailing list
> >TowerTalk@contesting.com
> >http://lists.contesting.com/mailman/listinfo/towertalk
>
>_______________________________________________
>
>See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless 
>Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with 
>any questions and ask for Sherman, W2FLA.
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

Bill Aycock - W4BSG
Woodville, Alabama 


_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>