Sounds like a good fit to me. It is not unusual to find 25g legs bent by
more than that in shipping. Sounds like time for a piece of pipe over the
end of the leg and a little elbow grease to make them line up exactly. It
also wouldn't surprise me if the pr25g was a bit misaligned and could
benefit from a bit of grease itself.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of W7QEB@wmconnect.com
> Sent: Sunday, August 14, 2005 20:12
> To: towertalk@contesting.com
> Subject: [TowerTalk] pr25g
>
> I have tried to install standard 25g section to the pr25g. The uprights
> are
> 1/32" too wide to accommodate 25g standard section
>
> Jim/W7QEB
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
> Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
> any questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|