Jim:
I use marine grease to lube my bearing at the top of my tower. I
bought a kit of three tubes of the reddish-colored stuff at a boat/marine
store when I put up my tower in 2001 and still have two left. But mind
you - the stuff does NOT wash off! It is, after all, water-repellent.
73 de
Gene Smar AD3F
----- Original Message -----
From: "Jim Plummer" <k8ary@yahoo.com>
To: <towertalk@contesting.com>
Sent: Saturday, September 03, 2005 7:36 PM
Subject: [TowerTalk] Thrust Bearing Maintenance
> I recently took down my tower to relocate to another QTH. The thrust
bearing was a bit sluggish. Upon disassembling, I found the roller bearings
on the base mounting side to be a bit rusty and entire inside of the
assembly dirty. I cleaned the bearings and bearing races and reassembled.
This greatly improved the smoothness when turning. I would like to replace
the rusty bearings. Does anyone have a source? Also, my instincts dictate
that this assembly should be lubricated. What is the proper lubricant for
this type of bearing?
>
> de Jim - K8ARY
>
>
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|