>
> Tom,
>
> Read your post...I'm confused.
>
> Define "MFJ Tuner/SWR Bridge"
> and "MFJ Tuner".
>
> Initially, I assumed you meant that you used a 259B to tune
> the stubs...then put them on line after the switch, and
> observed from an inline antenna tuner/swr bridge.
Yep, that'w what did (kinda sorta). I put the stub on a "T" connector on
the 259 with a dummy load on the other side. I got it where I wanted it,
then put it on the output of the switch. Where I measured it from was right
at the output of the transmitter--through the line from the rig to the MFJ
tuner and line to the antenna switch. I now know the error of my ways.
> These are open halfwave or shorted quarterwave stubs?
> Describe the switch itself. And, finally, what is it you're trying
> to achieve? Isolation between stations in a M/M environment?
These are both open and shorted bandpass stubs for station isolation in a 2
radio setup. 73
Tom W7WHY
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|