Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower Height Question

To: "'TowerTalk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Tower Height Question
From: "W0MU-Mike Fatchett" <w0mu@w0mu.com>
Date: Tue, 13 Sep 2005 10:20:16 -0600
List-post: <mailto:towertalk@contesting.com>
Compared to my inverted v at 50 ft, a beam at 120ft will do better.  120ft
is close to 1/2 wave length while 190 is close to 3/4 wavelength.  I am not
sure what the models would say but higher is usually better for DX on that
band.  Obviously there are significant costs involved with adding another
70ft of tower.  

Good Luck!

Mike W0MU

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Keith Dutson
Sent: Tuesday, September 13, 2005 9:06 AM
To: TowerTalk
Subject: [TowerTalk] Tower Height Question

I am planning to put up a 2el 80 meter Yagi.  The maximum tower height at my
QTH is 190 feet due to location near an airport and other restrictions.
However, I would rather use a 120 footer for this antenna.  The terrain is
typical Texas Gulf Coast (flat) and about 50 miles inland.  In your opinion,
will this lower installation still be good for DX contacts?

73, Keith NM5G

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>