Ferico:
I have a small yard for my 64-foot tall tower. The tower supports a
triband Yagi (Bencher Skyhawk) and a rotatable 40M dipole (Cushcraft D40) on a
15 foot mast above the tower top. I use a shunt-feed system to load the entire
tower on 160M. It works well for me.
Phil KB9CRY recently posted some photographs of his tower's shunt-feed
system which looks a lot like my tower and many others'. His photos are at:
http://nidxa.org/kb9cry_shunt_fed_tower.htm . The shunt-feed system is one or
more parallel wires held about two feet off the tower. The wires go from
ground level up to perhaps 45 feet on your tower. At that point the wires are
connected to the tower itself.
At the bottom of the tower, the ends of the shunt wires are connected to
one side of a transmitting (HV) variable capacitor of about 500 pF maximum.
The other side of this capacitor is connected to the center conductor of your
coaxial cable feedline. The coax shield is connected to the tower and its
ground system (two wires for you.)
You then feed a bit of power (QRP from your transmitter or from your
antenna analyzer) at 1.84 MHz (or your favorite DX spot on 160M) and adjust the
capacitor for best SWR. If you cannot get a good SWR setting, then change the
position of the wire on the tower (move it up or down a foot or so.) Adjust
the capacitor again. This configuration (a single series capacitor) is called
a Gamma match, just like feeding a Yagi on HF.
If this match won't work, you can add a second capacitor from the shunt
wire to ground/earth. These two capacitors make another type of matching
system called an Omega match. You adjust the shunt capacitor for minimum
reactance as shown on your analyzer, then adjust the series capacitor for best
SWR. If you don't have an anlayzer, then feed QRP to the antenna and adjust
the shunt cap then the series cap, then repeat, until you have a good match.
I would be pleased to answer any questions you might have about loading
your tower on 160M. I have been very happy with my tower's performance on
Topband and have helped several Hams here in the USA to construct a similar
system.
Good Luck and 73 de
Gene Smar AD3F
-------------- Original message ----------------------
From: "Federico Zanini IK3UMT" <ik3umt@ir3ip.net>
> Hi all,
>
> My station is located in a little city lot , let's say about 115 X 65 ft
> Dream of all hams in my condition is to have somewhat "Magic" antenna to
> work topband DX in a so limited space.
> Can you suggest us best antenna(s) to use ??
> Surely a tx one and a rx one will be used.
> My house is on lot center, tower is 53 feet high, with insulated guy wires,
> grounded with two ground rods but i have no way to install any kind of
> radials or other high supports.
> On top there is a hf quadriband yagi with a warc one stacked.
> Preferred way is to have an antenna that doesn't need good ground.
> Other thing to keep in mind : at North, East, South-East and South , there
> are 8mt high , 2 floor houses very close to my garden, will they greatly
> affect patterns of eventually ground-mounted antennas (i.e. transmitting
> verticals or k9ay)???
> Let me know, I hope your answers may be helpful for other operators.
>
> HNY
> 73 de Federico
> ik3umt
>
>
> _______________________________________________
> Topband mailing list
> Topband@contesting.com
> http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|