I should have added, the base plate is approx 7" square and the round
pipe is 4" (going off of memory here as I no longer have the base or
tower). The tower is offset away from the house/roof if you mount it
that way! If the pictures don't give you enough info I'll dig out my
notes.
Dino - K6RIX
dino@k6rix.com
> -------- Original Message --------
> Subject: Re: [TowerTalk] marb-550
> From: Dino Darling <dino@k6rix.com>
> Date: Wed, July 05, 2006 7:31 pm
> To: kt_7g_macro@comcast.net
> Cc: towertalk@contesting.com
>
> I quickly threw up some pictures for you and a link to the drawing on US
> Tower's site...
>
> http://www.ustower.com/550fs.pdf
>
> http://www.k6rix.com/ma550/
>
> Dino - K6RIX
> dino@k6rix.com
>
>
> > -------- Original Message --------
> > Subject: [TowerTalk] marb-550
> > From: kt_7g_macro@comcast.net
> > Date: Wed, July 05, 2006 9:55 am
> > To: towertalk@contesting.com
> >
> > I am looking for a drawing , aerial view, of the various parts of the rotor
> > base. My lot is shallow and I need to lay it down at an angle to prevent
> > working on the antennas in my neighbors yard. I also need to get it as
> > close to the eaves as possible to mitigate the visual impact on the spouse.
> > --
> > Rick Smith
> > KT7G
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|