Way, yes... simple, not really. There are meters made for measuring ground
system resistance, but they rely on either a very good reference ground
nearby, or a couple of rods spaced the right distances apart to act as a
reference. Its been some years since I used one so I forget the exact
process, but its spelled out in detail in the manuals. The one I used last
was made by Biddle if I remember correctly. Check with a local electrician
or electric company crew, they may have one and could make the measurements
for you. Or the meters can be rented from electronic rental places if you
want to do it yourself.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of John Cowan
> Sent: Tuesday, August 08, 2006 22:08
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ground Resistance
>
> I have followed the posts on radials and ground resistance for some time.
> Is there any simple way to measure the impedance of the ground radial
> system as you install them to know when you have enough of them in the
> ground?
>
> John
>
>
> ---------------------------------
> Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great
> rates starting at 1¢/min.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|