Depends on the size of the beam and the length of the mast and how much you
want to pay.... personally I use either 1/2" wall aluminum or 1/4" wall
steel.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Michael Mark, P.Eng.
> Sent: Thursday, August 24, 2006 17:33
> To: towertalk@contesting.com
> Subject: [TowerTalk] TOWER MAST - WHAT DO YOU THINK IS BEST
>
> I am installing a beam on a tower and am wondereing what you think is best
> for a 2" O.D. Mast.
>
> 1/4" wall Aluminum
>
> Stainless Steel
>
> Galvanized
>
> Electrical EMT is measured in I.D. not O.D. so that is a problem for 2"
> O.D. because 2" EMT is more than 2" O.D.
>
> 73
>
> Mike, VE4MM
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|